SUMMARY

The aim of this course is to provide an overview of the inspection of in-service lifting equipment as required by the Statutory Instruction SI 2307. The course reviews the requirements of the Provision and Use of Work Equipment Regulations 1998 (PUWER) and Lifting Operations and Lifting Equipment Regulations 1998 (LOLER) along with other relevant legislation. The course looks at the documentation required and various inspection techniques used.

Although a basic course, the content is quite substantial and covers the following areas:
• Runway Beams and Padeyes
• Beam Trolleys
• Beam Clamps
• Chain Blocks
• Shackles
• Webbing and Round Slings
• Wire Rope Slings
• Chain Slings
• Eyebolts
• Plate Champs
• Lifting and Pulling Machines
• Rigging Screws
• Jacks
• Swivel Hoist Rings
• Lever Operated Chain Hoists
• Wedge and Sockets

KEY LEARNING OUTCOMES

• Complete a thorough examination on Lifting accessories
• Understand the stresses and strains applied on lifting accessories
• Make an informed decisions if the lifting accessories are fit for a further period of service
• Complete a defect report sheet and take lifting accessories out of service

TARGET AUDIENCE

• Lift Engineer / Supervisor
• Rigger / Rigging Supervisor
• Transport & Lifting Supervisor
• Offshore Installation Engineer
• Marine Engineer
• LOLER Focal Point
• Crane Operator

INVESTMENT

SGD 3,295 per delegate (Classroom Training)

Request For Brochure